Oracle Data Integrator Tutorial- ODI for beginners

I am going to be writing up a few posts and tutorials on the basics of the architecture (see previous post) and a few beginner topics to get the masses in a mode where they are not intimidated by this tool. The previous post described various aspects to ODI, and the architecture. We saw various GUIs that ODI allows us to use. This post (and possibly another one or two) will look at the DESIGNER GUI in more detail.

One of the first things I will say is that the tool can feel a bit foreign if you come from an Informatica/OWB type background like myself. The emphasis is on building smaller and reusable pieces of code, if you will. Other tools that tend to be more ETL based (Informatica) and also more GUI and non-declarative based (OWB) are not necessarily the easiest tools to break things into small pieces. Yes, there are many that say breaking mappings into smaller pieces is a best practice, but the tool doesn't necessarily thrive on your ability to follow that practice. They don't really revolve around that practice. There are even mapplets and pluggable mappings, but these pale in comparison to the design methodologies that ODI offers. ODI thrives on code re-use.

For example, the diagram below shows a typical ETL/ELT from something that may come out of OWB or Informatica (a bit bigger, defined, and manual).
The following is the type of development that ODI supports and emphasizes for code reuse:


If you are a beginner to ODI and used other ETL/ELT tools and yoou are beginning to build out mappings you'll notice many of the mappings you'll build will be more discrete, if you will. There are also many steps that are done for you. You can build mappings quite fast in ODI actually. However, do not be too worried that that tool does quite a bit for you. Like Oracle's JDeveloper tool, you can get into most of the gory details if you'd like to fine-tune certain aspects, even if the tool does much of the work for you.

You will do the bulk of your work doing mappings in the following interface:


A brief description of what we see above in the Diagram above. First, notice that the Diagram TAB is selected on the top. This opens the diagramming tool where 'mappings' are built. In the middle are the data sources. These sources are physically dragged and dropped from the far left pane of the GUI to this 'sources' section and are then joined, filtered, and so forth. The right side of the GUI is labeled as the TARGET datastore. This is your target. For a beginner, this can be a bit confusing if you're used to OWB because here, the sources and target is separated by differnet parts of the GUI. You would drag your TARGET table to this target datastore pane in the GUI and not into the same area as the sources. So, a bit different in that respect.

Below is a zoom in on only the mapping portions of the tool. Again, on the left are the source portions of the mapping diagram, and on the left is the target datastore. You might not use the terminology 'datastore' too often, but in this tool you should get used to seeing that term a lot!
Here is another screenshot of the far left portion of the main GUI, which I tend to call the 'explorer' since it is built out like many software tool's explorer-like interfaces.
Again, one final screenshot to tie it all together what we have seen so far:

In the next posting, I will go into a bit more detail on the 'explorer' and the many tabs and options available within. As you might have imagined, these 'mappings' have been created and opened from the explorer on the left, and they are technically referred to as 'interfaces'. I'll talk a bit more on the concept of interfaces, and go into a bit more detail on working with your interfaces (A.K.A. mappings to most of us).